Monaco opens Energy Class catamaran redesign to student teams

Image
Monaco opens Energy Class catamaran redesign to student teams

MONACO -- November 19, 2026 -- The Yacht Club de Monaco (Y.C.M.) is asking university teams to redesign the hull of its Energy Class catamaran, the one component it has supplied identically to every team since the class was created in 2018. The Monaco Energy Class Design Challenge 2027, launched on November 3, raises the maximum length from about 5 m to 5.50 m, roughly 10% more, and the maximum width from 2.50 m to 2.70 m, about 8% more.

Teams must fit 35 kW of continuous power into a 300 kg limit

The rules set hard limits, and any breach eliminates an entry. The structures and interfaces must take a total continuous power of up to 35 kW, including thrust, torque, impact and transient loads. The complete boat, excluding the hulls, may not exceed 300 kg in race mode. That figure includes a pilot of at least 70 kg, which by our calculation leaves at most 230 kg for everything else.

The catamaran must meet design category C, which applies to pleasure boats in France. That means operation up to force 6 on the Beaufort scale and in waves up to 2 m. Foil-assisted concepts are allowed, but full flight is excluded and the boat must remain a surface craft.

The hull must stay a common base that accepts different motors, energy sources and cockpit layouts. It may not favour one technology. Entrants must also show it can be built as a prototype and then as a series of ten units at controlled cost. The organizer did not disclose a cost ceiling for that series.

Entries close May 1, 2027, and finalists learn their selection on June 1

Teams have 179 days from the launch to the deadline by our calculation. An optional checkpoint falls on March 12, 2027. Full dossiers, in English, are due on May 1, and the review runs through May. Y.C.M. will notify finalists on June 1.

Finalists defend their designs before an international jury at the 14th Monaco Energy Boat Challenge, held June 29 to July 3, 2027, 28 days after notification. The design selected receives €1,000.

The competition is open to students of naval architecture, marine engineering, hydrodynamics, composite materials and industrial design. Teams may mix disciplines and take outside advice, provided they remain the principal designers.

The winning design still faces engineering studies before any adoption

Winning does not make a design the new class hull. It must first pass engineering studies, a possible prototype and tests before Y.C.M. decides on adoption. Y.C.M. says the aim is a platform that could equip future editions of the Energy Class.

Published by:
fairsonline_team
Products
Target market(s)
News Type